Jandy Pool Products AquaLink RS Serial Adapter

Provides RS-232 control utilizing the Jandy AquaLink RS Serial Adapter. A null modem is not required. Install the isolator that is included with the Serial Adapter.

General Settings

Serial Port: Choose the serial port that the RS Serial Adapter is connected to. The default baud rate for the Serial Adapter is 9600.

Variables

Air Temp

Pool Setpoint

Pool Temp

Spa Setpoint

Spa Temp

Pool Heat (On/Off)

Pool Pump (On/Off)

Spa Heat (On/Off)

Spa Mode (On/Off)

Aux1 – Aux7 (On/Off)

Extra Aux (On/Off)

Aux3 – Aux7 Dimmer Level

Solar Heat (On/Off)

Solar Temp

Driver Commands

Aux1 – Aux7 and Extra Aux On/Off/Toggle

Pool Pump On/Off/Toggle

Pool Heater On/Off/Toggle

Pool Setpoint Up/Down

Spa On/Off/Toggle

Spa Heater On/Off/Toggle

Spa Setpoint Up/Down

Aux3 – Aux7 Dim Up/Down

Solar Heater On/Off/Toggle

Notes

Requires AquaLink Power Center firmware version "I" or above and RS Serial Adapter fimware version "C01".

Check the solar heater option box if a solar temp sensor is installed. This enables the driver to poll for the solar heater water temperature.

Pool Temperature is only available when the pool pump is on. There is a delay between the turn on of the pump and availability of temperature reading.

Spa Temperature is only available when the spa mode is on. There is a delay between the turn on of spa mode and availability of temperature reading.

Aux outputs that have been assigned to dimmers can be controlled. Level can only be changed when the output is on. Level adjustment is in 25% steps.

Filter pump low speed, pool cleaner, pool heater #2 and spa spillover (waterfall) are not supported in version 1.0.